Arthur_Martin AKG611A3OX Manual do Utilizador descarregar pdf (Página 27)

Adjusting the minimum gas

level on the oven burner

1. Disconnect the appliance from the

electricity.

2. Remove the knob for the oven

functions. If there is no access to the

bypass screw dismount the control

panel before adjustment start.

3. With a thin and flat screwdriver adjust

the bypass screw A.

The model determines the position of

the bypass screw A.

A

Changing from natural gas to

liquid gas

1. Fully tighten the bypass screw.

2. Put the knob back.

3. Connect the appliance to the

electricity.

Changing from liquid gas to

natural gas

1. Unscrew approximately one turn the

bypass screw position A.

2. Put the knob for the oven functions

back.

3. Connect the appliance to the

electricity.

WARNING! Put the mains

plug into the mains socket

only if all parts are back into

their initial position. There is

a risk of injury.

4. Light the burner.

Refer to "Oven - Daily use" chapter.

5. Turn the knob for the oven functions

on the minimum position.

6. Remove the knob for the oven

functions again.

7. Screw on slowly the bypass screw till

the flame becomes minimum and

stable.

8. Put the knob for the oven functions

back.

9. Set the maximum gas flow position on

the knob for the oven functions and let

the oven heat for at least 10 minutes.

10. Quickly turn the knob for the oven

functions from maximum to the

minimum gas flow position.

Control the flame. Make sure the flame

does not go out when you turn the knob to

the minimum gas flow position. There

must be a small regular flame on the oven

burner crown. If the flame goes out adjust

the oven burner again.

Gas grill injector replacement

1. Release the screws which keep the

grill burner in position A.

A

2. Release the burner injector with a 7

mm socket spanner and replace it with

a right one.

27

1 2 ... 22 23 24 25 26 27 28 29 30 31 32

Comentários a estes Manuais

Sem comentários